How to assemble the Ferrari machine tools.
If you want to know how to make your own Ferrari machine, this is the article for you.
Step one: Remove the top cover and top blade.
It will look like this:Step two: Remove all the screws.
It won’t look like much, but they are a part of the machine.
You can also remove the top screw.
Step three: Remove a rubber ring from the bottom of the tool.
Step four: Remove some nuts from the front of the lever.
Step five: Remove an extra set of screws.
You may notice that they are all screwed into the tool rather than on the lever as in the picture.
This is because you will need to loosen the bolt on the machine screwdriver.
It is also important to remove the rubber ring around the top of the screwdriver so you don’t have to remove it again.
Step six: Pull the lever to the side.
If everything is working, you should see the top handle and handle spring.
Step seven: Remove this spring.
The spring is on the inside of the blade, so you will have to get it off.
Step eight: The top handle will need a new rubber ring.
This rubber ring can be found at a hardware store or online.
I bought mine at Target.
It was about $3.50.
It can also be found on eBay, Amazon, or at your local craft store.
Step nine: The tool is ready to use.
You will notice that it’s quite heavy.
It also looks a bit like the picture above.
You want to loosen a little more than you think you need.
Step 10: Turn the tool over and inspect the top and bottom handles.
You should see some rust on the handles.
I think this rust was caused by the rubber on the blades.
The rust will fade away.